水处理工业污水钢厂废水处理设备天通设备精益求精

使用微信扫描二维码分享朋友圈，成交更快更简单！

水处理工业污水钢厂废水处理设备天通设备精益求精

工业污水处理工艺基本要求
,工业污水处理是我国工业发展方面一项重头,工业污水处理关系到我国工业发展,关系经济民生大计,工业污水处理
1 工业污水处理工艺技术成熟、经济合理的原则进行总体设计，力求节能降耗、工程投资低、运行成本低、操作管理方便、工艺技术成熟的废水处理工艺流程。
2 工艺流程做到稳定、、抗冲击负荷能力强，运行灵活、设备布置合理结构紧凑;
3 工业污水处理设备选型、匹配得当，运行稳定可靠，，维护保养简单，使用寿命长;
钢厂废水处理工程概况
该钢厂形成600万吨/年生产规模时，平均排水量将达到4000m³/h。废水处理工程设计平均日处理能力9.6万米3，夏季大日处理能力10.8万米3,其中70%作为工业补水回到厂区管网，其余达标后排放。
该废水处理回用工程于2010年4月开工建设，20012年1月主体结构完工，2012年5月试运行，2012年8月交付生产。工程占地29500㎡，新建建、构筑物占地8041㎡，绿化覆盖率32%，静态投资为8643万元。
厂区全部废水经处理后达到排放标准，其中回用水经软化、过滤、消毒等深度处理后，达到生产用水标准。
本工程进水为典型的钢铁工业废水，有机污染物含量不高，可生化性差，不适宜采用生化方法降解。本项目主要采用物理化学法。作为工业补水，在回用水深度处理中增加去除暂时硬度、总碱度软化、过滤、消毒等工艺。
厂区排出的工业废水用管道输送至废水处理厂进水口。经过预处理部分，用粗、细格栅将来水中较大颗粒的漂浮物去除；再由提升泵到配水构筑物，在此投加混凝剂和石灰以及硫酸，然后将废水分配到高密度澄清池，除去水中的悬浮物和胶体物质，水的澄清度，同时外排水还有除氟工艺。总进水的70%经高密度澄清池处理后，再经V形滤池过滤并投加液氯消毒后，送往厂区作为工业水的补充水，总进水的30%经高密度澄清池处理至达标后排放。
济宁天通设备有限公司是一家从事水处理设备生产、销售集一体化的企业，经过不断的努力在国内外获得了供不应求的大好市场，赢得了客户的一致好评。
多年的发展历程，公司始终坚持创新、品质、服务、敬业、感恩的理念。采纳新创意，严格质量，的服务跟踪，坚持做出产品。
我公司主要产品：水处理设备，污水处理设备、废水处理设备、工业污水设备、农业废水设备、雨水净水设备、医院污水设备、钢厂废水设备、屠宰场废水设备、食品厂废水处理设备等多种设备，可根据要求定制水处理设备。
Basic requirements of industrial sewage treatment process
Industrial sewage treatment is an important part of industrial development in China, and industrial sewage treatment is related to industrial development of China, economic and livelihood of the economy, industrial sewage treatment
1 mature industrial wastewater treatment technology, economic and reasonable principle for overall design, makes every effort to saving energy and reducing consumption, lower engineering investment, low running cost, convenient operation and management, advanced and mature technology of wastewater treatment process.
2. The process can be stable, efficient, resilient to impact load, flexible in operation and reasonable structure of equipment layout;
3. Selection of industrial sewage treatment equipment, proper matching, stable and reliable operation, high cost performance, simple maintenance and long service life;
General situation of wastewater treatment project in steel mill
The average displacement of the steel plant will reach 4000m to the third/h when the steel plant is produced at 6 million tons/year. The average daily processing capacity of wastewater treatment works is 96,000 m 3, and the maximum daily processing capacity of the summer is 10.8000m 3. 70% of it is returned to the factory pipe network as industrial rehydration, and the remaining discharge after reaching the standard.
The waste water treatment recycling project started construction in April 2010. The main structure was completed in January, 20012. The trial operation was conducted in May 2012 and the production was delivered in August 2012. The project covers an area of 29500 ㎡, the new building and structures which covers an area of 8041 ㎡, green coverage of 32%, the static investment is 86.43 million yuan.
All waste water in the factory will meet the emission standard after treatment, and the water will reach the standard of production water after softening, filtering and disinfecting.
This engineering water is typical of steel industry wastewater, organic pollutant content is not high, but biochemical difference is not suitable for biodegradation. This project mainly adopts physical chemistry method. As an industrial rehydration, the process of removing temporary hardness, softening of total alkalinity, filtration and disinfection is added in the treatment of water reuse.
The industrial effluent discharged from the factory is piped into the water inlet of the waste water treatment plant. After the pretreatment part, the large particles in the water will be removed by means of coarse and fine grille. By lift pump to the water distribution structures, again in the dosing coagulant and lime and sulfuric acid, and then assigned to high-density clarifier and wastewater to remove the suspended solids in the water and colloidal substances, ensure the clarity of water, drainage and fluoride in process at the same time. 70% of the total water treated with high-density clarifier, then through v-type filtration process and after adding the liquid chlorine disinfection, sent to the factory as make-up water of industrial water, 30% of the total water discharged after high-density clarifier processing to amount to mark.
Jining day general equipment co., LTD. Is a company engaged in water treatment equipment production, sales integration enterprise, after continuous efforts won the demand of the market both at home and abroad, won the customer consistent high praise.
Over the years, the company has always adhered to the concept of innovation, quality, service, dedication and gratitude. Adopt new ideas, strict quality, all-round service tracking, insist on making high-quality products.
My company main products: water treatment equipment, sewage treatment equipment, wastewater treatment, industrial wastewater, agricultural wastewater, rain water purification equipment, hospital sewage equipment, steel plant waste water equipment, slaughterhouse wastewater treatment equipment, food factory waste water treatment equipment and other equipment, can professional custom according to the water treatment equipment.